Search

How do I use it?


How do I use it?
Fast, simple, & strong 
Any time you feel like you may become nauseated, you can begin to experience relief in 3 simple steps:
  1. Find the contact area on your wrist.
    The contact area for the metal parts of the ReliefBand® is on the underside of your wrist (either one), about 1 inch below the crease when you bend your hand, inside the two inner tendons. 
  2. Put on the conductivity gel.
    Clean and dry the contact area on your wrist and gently rub on a small amount of the gel (about the size of a pea), distributing it evenly over the contact area. 
  3. Place and activate the device.
    Place the ReliefBand so the center button on the face of the device is centered over the contact area. Press the Rx to turn on the device. If you do not feel a tingling in your two middle fingers, press again to increase the level of stimulation. The ReliefBand should be set to the highest comfortable level. 
When you feel that you no longer need the ReliefBand to help you control your nausea, just press the center button and hold it for 5 seconds. 

04A-135-B028-1

DISCLAIMER
The health information contained herein is provided for informational purposes only and is not intended to replace a discussion with a healthcare provider. All decisions regarding patient care must be made with a healthcare provider and consider the unique characteristics of each patient.

The information contained in reliefband.com is intended for use only by United States residents. Countries outside of the United States may have regulatory requirements, data measurements, or medical practices that may differ from those in the United States. Therefore, this information may not be appropriate for use outside the United States.

Legal Notices/Privacy Policy. Copyright 1996 - 2007 Neurowave Medical.
Chicago, Illinois, U.S.A.